WEP - 405
WEP-405 is a pigmented, water based,low VOC,two-part epoxy resin coating with a satin finish.
It is suitable for places that require wear resistance, corrosion resistance, oil resistance, heavy pressure resistance, seamless and easy to clean.
Uses
- Parking lot, automobile manufacturing, machinery manufacturing, chemical, textile, furniture and other manufacturing plants.
- Storage and assembly halls, maintenance workshops, garages, loading ramps, etc.
Advantages
- Good chemical resistance
- Easy application
- Good mechanical resistance
- Wear resistance
- Non-VOC
Application instructions
1. Substrate quality / Pre-treatment
- The concrete substrate must be sound and of sufficient compressive strength (minimum 211 kgf/cm²) with a minimum pull off strength of 15 kgf/cm².
- Substrate water content is less than 8%,maximum ambient humidity 85%
- All substrates must be clean, dry and free of all contaminants such as dirt, oil, grease, coatings and surface treatments, etc.
2. Mixing
- Prior to mixing, stir WEP-405 A mechanically. When all of WEP-405 A has been added to WEP-405 B, mix continuously for 30 seconds~1 minutes until a uniform mix has been achieved.
3. Application
- Apply WEP-405 by brush or roller.
- After the first application of WEP-405, wait 1day (+23°C) before applying the second application.
- At least 24 hours after the coating is completed, the follow-up work can be carried out .
-
Note:Operating time: 15-20 hours (temperature: + 15 ~ + 35 ° C).
4. Consumption
- 0.1 -0.2 kg /m² (one coat)
- Note: This figure is theoretical and does not include for any additional material required due to surface porosity, surface profile, variations in level and wastage etc.
5. Maintenance
- To maintain the appearance of the floor after application, WEP-405 must be regularly cleaned using rotary brush, mechanical scrubbers, scrubber dryer, wash and Vacuum techniques using suitable detergents.
6. Cleaning of tools
- Clean all tools and application equipment with thinner immediately after use.
- Hardened and/or cured material can only be removed mechanically.

WEP-405

WEP-405

WEP-405
Technical Information

Packaging / Storage
WEP-405 A:5 kg/bucket
WEP-405 B:20 kg/bucket
- Shelf Life:12 months from date of production if stored properly in original, unopened and undamaged sealed packaging
- Store dry at +5~+35 °C Protect from moisture, direct sunlight, flame sources and freezing.