Epoxy paint

EP-301

EP-301

Epoxy middle coating - EP-301
  • epoxy middle coating
  • epoxy middle coating
  • epoxy middle coating
  • epoxy middle coating
  • epoxy middle coating
  • epoxy middle coating
DETAIL
 

EP - 301

EP-301 is epoxy middle layer resin which is used as structure layer in the floor coating system. EP-301 has leveling and repair functions. It enhance ground leveling, impact resistance, mechanical strength, thickness, chemical resistance, etc.

Uses

   
 
  • EP-301 is used to create seamless floors in manufacturing plants, mechanical rooms, warehouses, commercial kitchens, restaurants, garages and service areas where heavy use, such as forklift traffic. Epoxy mortar system is designed to be used as a heavy duty coating.

Advantages

 
 
  • Impact resistant
  • High strength
  • Easy application
  • Chemical resistant
  • Wear resistance

Application Information



Application instructions

    
 

1. Substrate quality / Pre-treatment

  • The concrete substrate must be sound and of sufficient compressive strength (minimum 211 kgf/cm²) with a minimum pull off strength of 15 kgf/cm².
  • Substrate water content is less than 8%.
  • All substrates must be clean, dry and free of all contaminants such as dirt, oil, grease, coatings and surface treatments, etc.

 

2. Mixing

  • Prior to mixing, stir EP-301 A mechanically. When all of EP-301 A has been added to EP-301 B, mix continuously for 30 seconds~1 minutes until a uniform mix has been achieved.

 

3. Application

  • EP-301 is poured, spread evenly and control the material thickness by scrape rake. Even surfaces are achieved using a smoothing trowel. 

  • Note:  Add 1 ~ 2 times quartz sand if floor thickness is needed.

 

4. Consumption

  • 1.8 ~ 2 kg/m²/mm  (Add 1 ~ 2 times quartz sand)
  • Note: This figure is theoretical and does not include for any additional material required due to surface porosity, surface profile, variations in level and wastage etc.

 

5. Cleaning of tools

  • Clean all tools and application equipment with thinner immediately after use.
  • Hardened and/or cured material can only be removed mechanically.

EP-301
EP-301
EP-301

Technical Information



Packaging / Storage

   
 

 EP-301 A: 20 kg/plastic pail
 EP-301 B: 10 kg/plastic pail

 

  • 6 months in the original, unopened containers at temperatures between +5 °C and +30 °C. Stored in a well ventilated area away from direct sunlight, flame sources and freezing.